Cisco Systems OL-16647-01 Step 12 - Static Routes, Step 13 - DHCP Server

5-13
Cisco ASDM User Guide
OL-16647-01
Chapter 5 Using the Startup Wizard
Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
Step 12 - Static Routes
This screen lets you create, edit, and remove static routes that will access networks connected to a router
on any interface.
For More Information
• Static Routes, page 11-40
• Add/Edit Static Routes, page 5-13
• Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide and the Cisco ASA 5505
Getting Started Guide
Modes
The following table shows the modes in which this feature is available:
Add/Edit Static Routes
This dialog box lets you add or edit a static route. See Add/Edit Static Route, page 11-43 for more
information.
Step 13 - DHCP Server
This screen lets you configure the adaptive security appliance as a DHCP server to hosts on the inside
interface. To configure the DHCP server for other interfaces from the main ASDM application window,
choose Configuration> Properties > DHCP Services > DHCP Server. For more information, see
DHCP Server, page 13-4.
Fields
• Enable DHCP server on the inside interface—Check this check box to allow connection to the
DHCP server from the inside interface.
DHCP Address Pool area
• Starting IP Address—Specifies the starting range of the DHCP server pool in a block of IP addresses
from the lowest to highest.
Note The adaptive security appliance supports up to 256 IP addresses.
• Ending IP Address—Specifies the ending range of the DHCP server pool in a block of IP addresses
from the lowest to highest.
DHCP Parameters area
Firewall Mode Security Context
Routed Transparent Single
Multiple
Context System
• • • •—