16-8
Cisco ASDM User Guide
OL-16647-01
Chapter 16 Configuring Management Access
Configuring Configuring ICMP Access
To configure ICMP access rules, perform the following steps:
Step 1 From the Configuration > Device Management > Management Access > ICMP pane, click Add.
If you want to insert a rule in the ICMP table, click the rule that the new rule will precede, and click
Insert.
The Create ICMP Rule dialog box appears in the right-hand pane.
Step 2 From the ICMP Type drop-down list, choose the type of ICMP message for this rule.
Table 16-1 lists the types of ICMP messages.
Step 3 From the Interface selection list, choose the destination security appliance interface the rule is to be
applied to.
Step 4 In the IP Address field, do one of the following:
• Add a specific IP address for the host or network.
• Click Any Address and go to Step 7.
Step 5 From the Mask drop-down list, choose the network mask.
Step 6 Click OK.
The dialog box closes.
Table 16-1 ICMP Type Literals
ICMP Type Literal
0 echo-reply
3 unreachable
4 source-quench
5redirect
6 alternate-address
8echo
9 router-advertisement
10 router-solicitation
11 time-exceeded
12 parameter-problem
13 timestamp-request
14 timestamp-reply
15 information-request
16 information-reply
17 mask-request
18 mask-reply
31 conversion-error
32 mobile-redirect