1-4
Cisco UCS C22 Server Installation and Service Guide
OL-26646-01
Chapter1 Overview
WoL The 1-Gb Base-T Ethernet LAN ports support the wake-on-LAN (WoL) standard.
Power One 450 W power supply or one 650W power supply.
See also Power Specifications, pageA-2.
ACPI This server supports the advanced configuration and power interface (ACPI) 4.0
standard.
Cooling Five fan modules for front-to-rear cooling.
PCIe I/O Two horizontal PCIe4 expansion slots on risers.
See Replacing a PCIe Card, page 3-34 for slot specifications.
Note In a single-CPU configuration, only PCIe slot 1 is active.
InfiniBand The bus slots in this server support the InfiniBand architecture.
Storage Drives are installed into front-panel drive bays that provide hot-pluggable access.
There are two versions of the server front panel and backplane:
•Small Form Factor drives—The server can hold up to eight 2.5 in. (63.5 mm)
SAS5 or SATA6 hard drives or solid state drives.
•Large Form Factor—The server can hold up to four 3.5 in. (82.5 mm) SAS or
SATA hard drives.
Internal USB
support
The server has one internal USB 2.0 socket on the motherboard that you can use with
a USB thumb drive for additional storage.
The server can be ordered with an optional blank 8-GB Cisco USB Flash Drive
pre-installed in the internal USB port.
Disk
Management
(RAID)
For a list of RAID7 controller options and required cables, see RAID Controller
Considerations, pageC-1.
RAID Backup There is one mounting point inside the chassis that can be used for the SuperCap
power module that can be used with an LSI MegaRAID-CV card.
Video Matrox G200e video controller. Resolution up to 1920 x1200, 16bpp at 60 Hz. Up
to 256 MB of video memory.
1. DIMM = dual inline memory module
2. VGA = video graphics array
3. USB = universal serial bus
4. PCIe = peripheral component interconnect express
5. SAS = serial attached SCSI
6. SATA = serial advanced technology attachment
7. RAID = redundant array of independent disks
Table1-1 Cisco UCS C22 Server Features (continued)