Cisco Systems OL-26646-01 manual RAID Controller Card Cable Routing

Chapter 3 Maintaining the Server

Installing or Replacing Server Components

h.If the card that you replaced was a RAID controller, continue with Restoring RAID Configuration After Replacing a RAID Controller, page C-22.

Special Considerations for Cisco UCS Virtual Interface Cards

Table 3-8describes the requirements for the supported Cisco UCS virtual interface cards (VICs).

Table 3-8	Cisco UCS C22 Requirements for Virtual Interface Cards
		Number of		Primary Slot For		Minimum VIC	Minimum Nexus
		VICs	Slots That	UCS Integration	Minimum	Firmware For	OS on an Upstream
Virtual Interface Card		Supported	Support	or Cisco Card	Cisco IMC	Use With UCS	Nexus Fabric
(VIC)		in Server	VICs1	NIC Mode	Firmware	Integration	Interconnect
Cisco UCS VIC P81E2		1	PCIE 1	PCIE 1	1.4(5)	2.0(2)	5.0
N2XX-ACPCI01
Cisco UCS VIC 1225		1	PCIE 1	PCIE 1	1.4(6)	2.1(0)	5.0
UCSC-PCIE-CSC-02
Cisco UCS VIC1225T		1	PCIE 1	PCIE 13	1.5(1)	2.1(1)	5.0
UCSC-PCIE-C10T-02
Cisco UCS VIC1285		1	PCIE 1	PCIE 1	1.5(4)	2.2(1b)	5.0
UCSC-PCIE-C40Q-02

1.See PCIe Slots, page 3-34.

2.See note below.

3.The Cisco UCS VIC1225T is not supported for UCS integration at this time.

Note The Cisco UCS VIC P81E is not supported in the C22 Large Form Factor version of the server.

RAID Controller Card Cable Routing

If the PCIe card that you are installing or replacing is a RAID controller card, see RAID Controller Considerations, page C-1for required cables and cable routing guidelines.

See also Replacing the SuperCap Power Module (RAID Backup Unit), page 3-41for instructions on installing a RAID backup unit for a RAID controller card.

	Cisco UCS C22 Server Installation and Service Guide
3-36	OL-26646-01