Cisco Systems PA-4T manual Preparing for Installation, Tools and Parts Required

C H A P T E R 2

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing the PA-4T+ port adapter.

•

•

•

•

Tools and Parts Required, page 2-1

Software and Hardware Requirements, page 2-2

Safety Guidelines, page 2-3

FCC Class B Compliance, page 2-5

Tools and Parts Required

You need the following tools and parts to install a port adapter. If you need additional equipment, contact a service representative for ordering information.

•PA-4T+(=) port adapter and one of the following:

—VIP2-15(=) if you are installing only one PA-4T+; otherwise, we recommend a VIP2-40(=) or VIP2-50(=)

—Cisco 7200 series router with at least one available port adapter slot

—Cisco uBR7200 series router with at least one available port adapter slot

—Cisco 7100 series router with at least one available port adapter slot

•Serial cables appropriate for the desired port adapter interface types and the desired modes. (See the “LEDs” section on page 1-15.)

•Number 1 Phillips and a 3/16-inch, flat-blade screwdriver.

•Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares.

Preparing for Installation 2-1