Cisco Systems PA-4T manual VIP2 show interfaces Command

Checking the Configuration

VIP2 show interfaces Command

Following are examples of how the show interfaces [type slot/port-adapter/port] command displays status information (including the physical slot and port address) for the interfaces you specify. The four PA-4T+ interfaces (0–3) are in interface processor slot 3, in port adapter slot 1.

Router# show interfaces serial 3/1/0 Serial3/1/0 is up, line protocol is up

Hardware is cyBus Serial Internet address is 10.10.10.1

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive set (10 sec)

[display text omitted]

Router# show interfaces serial 3/1/1 Serial3/1/1 is up, line protocol is up

Hardware is cyBus Serial Internet address is 10.10.10.2

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive set (10 sec)

[display text omitted]

Router# show interfaces serial 3/1/2 Serial3/1/2 is up, line protocol is up

Hardware is cyBus Serial Internet address is 10.10.10.3

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive set (10 sec)

[display text omitted]

Router# show interfaces serial 3/1/3 Serial3/1/3 is up, line protocol is up

Hardware is cyBus Serial Internet address is 10.10.10.3

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive set (10 sec)

[display text omitted]

8-18PA-4T+ Synchronous Serial Port Adapter Installation and Configuration