Installing a Port Adapter

Figure 3-3 Location of Port Adapter Screw—Partial Port Adapter View

H3148

Screw

Step 5 Remove the screw that secures the port adapter (or blank port adapter).

Step 6 With the screw removed, grasp the handle on the front of the port adapter (or blank port adapter) and carefully pull it out of its slot, away from the edge connector at the rear of the slot. (See Figure 3-4.)

Figure 3-4 Pulling a Port Adapter Out of a Slot—Partial Port Adapter View

H3149

Step 7 If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the factory. If you removed a blank port adapter, no special handling is required; however, store the blank port adapter for potential future use.

This completes the procedure for removing a port adapter from a VIP2.

Installing a Port Adapter

Step 1 Remove the new port adapter from its antistatic container and position it at the opening of the slot. (See Figure 3-5.)

Caution To prevent jamming the carrier between the upper and lower edges of the port adapter slot, and to assure that the edge connector at the rear of the port adapter mates with the connector at the rear of the port adapter slot, make certain that the leading edges of the carrier are between the upper and lower slot edges, as shown in the cutaway in Figure 3-5.

3-4PA-4T+ Synchronous Serial Port Adapter Installation and Configuration

Page 34
Image 34
Cisco Systems PA-4T manual Installing a Port Adapter, Location of Port Adapter Screw-Partial Port Adapter View