Cisco Systems PA-4T manual Port adapters

Removing a Port Adapter

Note The Cisco uBR7200 series supports online insertion and removal (OIR); therefore, you do not have to power down the router when removing and replacing a PA-4T+.

When a port adapter slot is not in use, blank port adapters must fill empty slots to allow the router to conform to EMI emissions requirements and to allow proper air flow across the port adapters. If you plan to install a new port adapter in a slot that is not in use, you must first remove the blank port adapter.

Removing a Port Adapter

Take the following steps to remove a port adapter from a Cisco uBR7200 series:

Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.

Step 2 Place the port adapter in the unlocked position.

•For the Cisco uBR7246, place the port adapter retention clip for the desired port adapter slot in the unlocked position. The port adapter retention clip remains in the unlocked position. (See Figure 5-2.)

Figure 5-2 Placing the Port Adapter Retention Clip in the Unlocked

Position—Cisco uBR7246

Port adapters

H11518

Port adapter retention clip in unlocked position

5-2PA-4T+ Synchronous Serial Port Adapter Installation and Configuration