Cisco Systems PA-4T manual H3152

Installing a Port Adapter

Figure 3-6 Port Adapter Installed in a Port Adapter Slot—Partial Port Adapter View

H3152

Step 4 Replace the screw in the rear of the port adapter slot. (See Figure 3-3 for its location.) Do not overtighten this screw.

Step 5 Reinstall the VIP2 in the system. (Follow the steps in the section “Installing a VIP2” in the configuration note Second-Generation Versatile Interface Processor (VIP2) Installation and Configuration , which shipped with your VIP2.)

Step 6 If disconnected, reconnect the interface cables to the port adapters.

This completes the procedure for installing a port adapter on a VIP2. Proceed to Chapter 7, “Installing the PA-4T+ Interface Cables,” to connect the necessary cables to your port adapter.

3-6PA-4T+ Synchronous Serial Port Adapter Installation and Configuration