
Checking the Configuration
Table |
| |
|
|
|
|
| Default Settings |
Timer | Command Syntax | (Milliseconds) |
|
|
|
CTS delay | 0 | |
|
|
|
CTS drop timeout | 250 | |
|
|
|
DCD drop delay | 100 | |
|
| |
DCD transmission start delay | 100 | |
|
|
|
RTS drop delay | 3 | |
|
|
|
RTS timeout | 3 | |
|
|
|
Transmit delay | 0 | |
|
|
|
Configuring Bisync
To configure
Checking the Configuration
After configuring the new interface, use the show commands to display the status of the new interface or all interfaces and the ping and loopback commands to check connectivity.
Using show Commands to Verify the New Interface Status
Use the following steps tiuse verify that the new interfaces are configured and operating correctly:
Step 1 | Use the show version command to display the system hardware configuration. Ensure | |
| that the list includes the new serial interfaces. |
|
Step 2 | Display all the current interface processors and their interfaces with the show controllers | |
| command. Verify that the new | |
Step 3 | Specify one of the new interfaces: |
|
| • Cisco 7100 series, Cisco 7200 series or Cisco uBR7200 series | |
| show interfaces [type slot/port] command. |
|
| • | |
| Verify that the first line of the display specifies the interface with the correct slot number. | |
| Also verify that the interface and line protocol are in the correct state: up or down. | |
Step 4 | Display the protocols configured for the entire system and specific interfaces with the | |
| show protocols command. If necessary, return to configuration mode to add or remove | |
| protocol routing on the system or specific interfaces. | |
Step 5 | Display the running configuration file with the | show |
| the configuration stored in NVRAM using the | show |
that the configuration is accurate for the system and each interface.
If the interface is down and you configured it as up, or if the displays indicate that the hardware is not functioning properly, ensure that the network interface is properly connected and terminated. If you still have problems bringing the interface up, contact a service representative for assistance.