Removing a Port Adapter

When a port adapter slot is not in use, a blank port adapter must fill the empty slot to allow the router to conform to EMI emissions requirements and to allow proper air flow across the port adapters. If you plan to install a new port adapter in a slot that is not in use, you must first remove a blank port adapter.

Removing a Port Adapter

Take the following steps to remove a port adapter from a Cisco 7200 series router:

Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.

Step 2 Place the port adapter lever for the desired port adapter slot in the unlocked position. The port adapter lever remains in the unlocked position. (See Figure 4-2.)

Figure 4-2 Placing the Port Adapter Lever in the Unlocked Position—Cisco 7206

 

 

 

 

 

 

 

 

 

 

TOKEN RING

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ETHERNET 10BT

 

 

 

FAST ETHERNET

 

 

 

 

 

 

 

 

ENABLED

 

LINK

RJ45

 

 

 

 

 

 

 

 

 

MII

 

4

3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

0

 

 

 

 

 

 

 

 

 

 

FAST SERIAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SLOT

1

FE

MII

 

FAST ETHERNET INPUT/OUTPUT CONTROLLER

 

H6596

 

 

 

 

 

 

 

 

 

0

ENABLED

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PCMCIA

EJECT

SLOT

0

 

 

MII

RJ45

RJ45

 

 

 

 

 

 

 

 

 

 

 

 

EN

EN

LINK

 

 

 

 

 

 

 

 

 

 

 

Port adapter

 

 

 

 

 

 

 

 

 

 

 

handle

 

 

 

 

Note: This adapter removal applies to any port or service adapter.

Port adapter

lever (unlocked

position)

Step 3 Grasp the handle on the port adapter and pull the port adapter from the midplane, about halfway out of its slot. If you are removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.

Note As you disengage the port adapter from the router midplane, OIR administratively shuts down all active interfaces on the port adapter.

Step 4 With the port adapter halfway out of the slot, disconnect all cables from the port adapter.

Step 5 After disconnecting the cables, pull the port adapter from its chassis slot.

Caution Always handle the port adapter by the carrier edges and handle; never touch the port adapter’s components or connector pins. (See Figure 4-3.)

4-2PA-4T+ Synchronous Serial Port Adapter Installation and Configuration

Page 38
Image 38
Cisco Systems PA-4T manual Port adapter Handle Lever unlocked Position