Chapter6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
6-28
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
To assign a downloadable PIX ACL to a group, follow these steps:
Step 1 In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
Step 2 From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 3 From the Jump To list at the top of the page, choose Downloadable ACLs.
Step 4 Under the Downloadable ACLs section, click the Assign PIX ACL check box.
Step 5 Select a PIX ACL from the list.
Step 6 To save the group settings you have just made, click Submit.
For more information, see the “Saving Changes to User Group Settings” section
on page 6-50.
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Configuring TACACS+ Settings for a User GroupPerform this procedure to configure and enable the service/protocol parameters to
be applied for the authorization of each user who belongs to the group. For
information on how to configure settings for the Shell Command Authorization
Set, see the “Configuring a Shell Command Authorization Set for a User Group”
section on page 6-30.
Note To display or hide additional services or protocols, click Interface
Configuration, click TACACS+ (Cisco IOS), and then select or clear items
in the group column, as applicable.