Chapter6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
6-38
Cisco Secure ACS 3.0 for Windows 2000/NT Servers User Guide
78-13751-01, Version 3.0
Step 6 To save the group settings you have just made, click Submit.
For more information, see the “Saving Changes to User Group Settings” section
on page 6-50.
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Configuring Cisco VPN 3000 Concentrator RADIUS Settings for a User Group
The Cisco VPN 3000 Concentrator RADIUS attribute configurations appear only
if both the following are true:
•A AAA client has been configured to use RADIUS (Cisco VPN 3000) in
Network Configuration.
•Group-level RADIUS (Cisco VPN 3000) attributes have been enabled on the
RADIUS (Cisco VPN 3000) page of the Interface Configuration section.
Cisco VPN 3000 Concentrator RADIUS represents only the Cisco VPN 3000
Concentrator VSAs. You must configure both the IETF RADIUS and Cisco VPN
3000 Concentrator RADIUS attributes.
Note To hide or display Cisco VPN 3000 Concentrator RADIUS attributes, see the
“Setting Protocol Configuration Options for RADIUS (CiscoVPN 3000)”
section on page 3-15.
To configure and enable Cisco VPN 3000 Concentrator RADIUS attributes to be
applied as an authorization for each user in the current group, follow these steps:
Step 1 Confirm that your IETF RADIUS attributes are configured properly.
For more information about setting IETF RADIUS attributes, see the
“Configuring IETF RADIUS Settings for a User Group” section on page 6-34.
Step 2 In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.