Cisco Systems SFS 7012 manual Connect Equipment to the Ports and Power On the System

Contents

	InfiniBand General Services Managers and Agents 6
	SNMP Support	7
	SNMP MIBs	7
	Installation 9
C H A P T E R 2
	Statement 1019—Main Disconnecting Device 10
	Statement 1045—Short-circuit Protection 11
	Statement 1074—Comply with Local and National Electrical Codes 13
	Statement 1075—Hazardous Voltage or Energy Present on DC Power Terminals 14
	Planning the Installation 15

	Environmental Requirements				15
	Rack Specifications and Recommendations							16
	Installing and Routing Cable				16
	Power Requirements			17
	Installation Tasks Checklist			18
	Safety Information		18
	Tools and Equipment Required					20
	Check the Installation Site				21
	Unpack the Equipment			21
	Installation Tasks	22
	Mounting Kit	22
	Mark the Rack	22
	Install the Rails in the Rack				22
	Rack-Mount the Switch			24
	Installing the Switch Face Plate					25
	Removing a Module or Blank				26
	Installing the Spine and Leaf Modules						26
	Connect Equipment to the Ports and Power On the System 27
	Bringing Up the System For the First Time							29
	Changing the SFS 7012 IP Address and Default Gateway via the CLI 30
	Updating Management Spine IP Addresses in a Redundant Management Configuration 31
	SFS 7012 Component LEDs				34
	SFS 7012 Leaf and Spine Module LEDs						35
	Accessing On-line Help		37
	Shutdown Procedures			38
	Rebooting Components from Chassis Viewer							38
	Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
ii								OL-8787-04