Chapter
Check the Installation Site
The SFS 7012 switch is designed to be installed in an existing server cabinet (not a telco cabinet), where it can be mounted in a standard equipment rack. Mounting brackets are integrated with the switch.
Be sure of the following:
•The cabinet has a full earth ground to provide reliable grounding.
•There is enough room to work on the equipment.
•The equipment will have enough clearance for front and rear access.
•The IB cables can be accessed easily.
•Water or moisture cannot enter the switch.
•The ambient temperature stays between 50° - 104°F (5° - 40° C).
•Cabinet doors do not interfere with
The cabinet should have its own power distribution (with switch). If the switch has two power supplies, it is suggested that a cabinet with dual power distribution units is used.
It is recommended that cabinet
Unpack the Equipment
Warning Read all installation instructions before connecting the system to its power source.
Step 1 Carefully open the box and unpack the SFS 7012 switch. The SFS 7012 is shipped fully populated and should contain.
–SFS 7012 Chassis
–Leaf modules (up to 12)
–Leaf module blanks (up to 11). These blanks populate unused leaf module slots to help maintain the thermal integrity of the chassis.
–Spine modules (up to 3)
–Spine module blanks (up to 2). These blanks populate unused spine module slots to help maintain the thermal integrity of the chassis.
–Power Supplies: up to six (6)
–Power supply blanks (up to 5). These blanks populate unused power supply slots to help maintain the thermal integrity of the chassis.
–Fans (4)
–Mounting hardware kits
Step 2 Inspect the equipment for any shipping damage and report any problems to the shipping company. Step 3 Verify that the equipment serial numbers match those on the packing slip.
Step 4 Resolve any issues with incorrect serial numbers or missing/incorrect parts before installing the equipment.
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
| 21 |
| |
|
|
