Chapter
Note The combination of the Transport Domain and the Transport Address determines the trap destination.
•Port
Specifies the TCP port which the SNMP trap will be sent.
•Timeout
Specifies the time that the trap sender waits on a response before
•Retry Count
Specifies the number of attempts to be made to send the trap after a timeout condition occurs.
Note Timeout and Retry Count are SNMP v2.c and above. Not applicable for v1 traps.
•Tag List
Specifies which traps should be sent to this particular destination.
Note RFC2233 specifies the link up/down traps. Including RFC2233 in the Tag List specifies that the trap receiver will get link up/down traps.
•Parameters
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of SNMP to use.
•Storage Type
This field determines whether or not the entry is saved for each reboot of the SFS 7012.
–Nonvolatile means that the value is saved, and remains with each subsequent reboot.
–Volatile or Other indicates it will not be saved.
•Status
Indicates the current status of the row. The row may be in one of three states:
–Active
–Not in service
–Not Ready
Note A status of not in service indicates that the current row will not be used in the event a trap is generated by the system. Toggling a trap to not in service, which temporarily suspends trap forwarding, may be useful to keep values intact.
SNMP Target Parameters:
•Parameter Name
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of SNMP to use.
•MP Model
The Message Processing Model to be used when generating SNMP messages for entry.
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
| 61 |
| |
|
|
