ClearSounds CSC50-ER manual Setting the Dialing Mode, Press the OK green button

5.Holding the phone slightly above the mounting screws on the wall jack, push the phone against the mounting screws so they are hooked into upper and lower key- hole slots on the back of the phone. Slowly slide the phone down until it snaps into place (See diagram #10).

6.Connect the handset coil cord (curly cord) to the handset and to the telephone.

7.Lift the handset and listen for a dial tone. If you hear a dial tone, your phone is ready to use. If there is no dial tone, check all your cords to make sure they are plugged in securely.

DIAGRAM #8 – Reversing The Hook DIAGRAM #9 – Mounting The Wall Bracket

DIAGRAM #10 – Wall Installation

SETTING THE DIALING MODE

The Tone/Pulse is factory pre-set to Tone (T). Please check with your local telephone company if uncertain of the type of service. You can review or change the settings as follows:

In the hook position (handset in cradle),

1.	Press the MUTE button to access the special features.
2.	Using the	or	arrow buttons (below the Caller ID Display), highlight <<SET
	PHONE>>.
3.	Press the OK (green) button.
4.	Using the	or	arrow buttons, scroll to select <<TONE MODE OR PUSLE
	MODE>>.

5.Press OK button.

6.Press the C button 3 times to exit.

12