![](/images/new-backgrounds/1263724/26372433x1.webp)
Revision D 12/09 | Chapter 2: Diagnostics and Configuration | 17 |
Communication interface
To change the communication interface settings, enter the configuration menu, select “Set Communication Interface” from the main menu and answer “Yes” to “SET INTERFACE TYPE?” printed on the receipt.
Caution: Be extremely careful changing any of the printer settings to avoid inadvertently changing other settings that might affect the performance of the printer.
Press the paper feed button as instructed to select the communication interface you want.
•Communication interface
•
• USB: | Auto when no |
RS-232C serial interface settings
To change the
Caution: Be extremely careful changing any of the printer settings to avoid inadvertently changing other settings that might affect the performance of the printer.
Press the paper feed button as instructed on the configuration menu to select the
• Baud rate 115200 baud 57600 baud 38400 baud 19200 baud 9600 baud 4800 baud 2400 baud 1200 baud
•Number of data bits (can not be changed)
•Stop bits (can not be changed)
•Parity (can not be changed)
•Hardware flow control
Software (XON/XOFF)
Hardware (DTR/DSR)
•Data reception errors
Ignore errors
Print “?”
•Alternate DTR/DSR
Enabled
Disabled
Note: Press the paper feed button for at least one second to validate the selection.
For more information about | See this section |
Setting the | “Configuring the printer” |
interface settings | on page 16 |