
Revision D 12/09 | Chapter 4: Programming Commands 81 |
Related information
This command is utilized in the TPG LogoEZ® utility. The utility can be used to
f = 1: s = 1H a = 30H
f = 2: s = 32H r = 19H
f = 3: s = 1H r = 7H t = 1H
f = 4: s = 30H a = A0H
Convert 6-dots/mm bitmap to 8-dots/mm bitmap
ASCII | US EOT n | |
Hexadecimal | 1F 04 n | |
Decimal | 31 04 n | |
Value: | 0 | = Off |
| 1 | = On |
| (When 0 and 1 are the LSB) | |
Default: | 0 | (Off) |
Selects or cancels
When the
Enable constant speed logos
ASCII | US { n | |
Hexadecimal | 1F 7B n | |
Decimal | 31 123 n | |
Value: | 0 | = disable |
| 1 | = enable |
This command allows the firmware to determine the optimal speed to print a logo. It is set prior to
downloading the logo and reset after the logo has been downloaded.
In general, “Set max target speed (1D A0 nl nh)” is the preferred command.