Compaq LA36 user manual Will turn blinking

Paper Handling

Operation		Required Conditions *1			Required Action
		Ready	Printing *2	Fault
Select a resident font		—	Not printing	Off	Press Font.
Enter Macro selection mode		—	Not printing	Off	Press Macro. (M1 and M2
					will turn blinking
					alternately for 3 seconds.)
	Select Macro 1	—	*4	Off	Press M1 within 3 seconds
					after pressing Macro.
	Select Macro 2	—	*4	Off	Press M2 within 3 seconds
					after pressing Macro.
Switch the protocol		—	Not printing *4	Off	Press Protocol.
Enter Top-of-Form Adjustment mode		—	Not printing	Off	Press Set-Up/Quit and Top.
	Move paper by 1/60 inch	Off	—	Off	Press	or	button.
	Use the adjustment temporarily	Off	—	Off	Press Set-Up/Quit.
	Use the adjustment permanently	Off	—	Off	Press Exit/Save.
	Clear the adjustment	Off	—	Off	Press Top.
Enter Set-Up mode		N/A	N/A	N/A	Turn power on while
					pressing Set-Up/Quit.
	Move cursor to select	Off	Not printing	Off	Press	or	button.
	a Set-Up Function or Value
	Move cursor to select	Off	Not printing	Off	Press	or	button.
	a Set-Up Option
	Select a Set-Up Function	Off	Not printing	Off	Press	or	button.
	or Value
	Select a Set-Up Value and	Off	Not printing	Off	Press Exit/Save.
	move cursor to SAVE&EXIT
	Quit Set-Up mode without	Off	Not printing	Off	Press Set-Up/Quit.
	saving values
Clear software-detected errors		—	—	Blinking	Press Pause.
Initialize the printer		—	—	—	Turn power off and on again.

*1 In Normal mode operation, all buttons except Pause are inactive in the Busy state in which the printer is receiving or printing data.

*2 Not printing includes the following situations: the printer is ready and awaiting data, or the Pause button is pressed and the printer is awaiting data, or the Pause button is pressed during printing.

*3 This operation is available in the rear-feeding push-tractor mode.

*4 Switching is not done if the printer is holding printing data.

2-6