International Standards Conformity
Federal Communications Commission (FCC) Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
FCC warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Notes
1.The use of a nonshielded parallel interface cable with the referenced device is prohibited. The length of the parallel interface cable must be 3 meters (10 feet) or less. The length of the serial interface cable must be 600 meters (1970 feet) or less.
2.The length of the power cord must be 3 meters (10 feet) or less.
Notice to Canadian Users
This digital apparatus does no exceed the class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’ émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de Ia classe B prescrites dans le Règlement sur le brouillage radioélectrique édicté par Ie ministère des Communications du Canada.
Declaration of Conformity
We, Compaq Computer Corporation, declare under our sole responsibility that this printer is in conformity with the following directives and standards:
•89/336/EEC on the Electromagnetic Compatibility based on compliance to:
-EN55022:1994 inc. A1:1995 and A2:1997 Class B radio frequency emissions
-
•73/23/EEC on the Safety of Low Voltage Equipment based on compliance to:
-EN60950 Safety of Information Technology Equipment
•93/68/EEC on the Labeling of Equipment
