Compaq R6000 Series manual Powering up the R6000 UPS, Turning on the Main Circuit Breaker

Installation 2-23

Powering up the R6000 UPS

Turning on the Main Circuit Breaker

After a licensed electrician has the Compaq R6000 UPS properly wired to utility power, and hardware installation is complete, turn on the AC Mains at the service panel circuit. The Compaq R6000 UPS will automatically initiate a self-test. If the self-test is completed successfully, the Compaq R6000 UPS enters Standby mode, designated by the blinking green LED.

Pressing the ON button

To power up the Compaq R6000 UPS, press the ON button ( ) (marked “ ￿”) until the Green LED glows solid. Load segments will go through a staggered turn-on sequence.

1

Figure 2-18. The Compaq R6000 UPS “On” button

Shutting Down the System

To shut down the system:

1.Place the UPS on Standby (See Chapter 3, “Operation”).

2.Disconnect the AC mains by opening switch or circuit breaker at the utility panel.