1 You need these tools for installation:
❒wire strain relief
❒16- or
❒set of Allen wrenches
❒½ inch open or box end wrench
❒flashlight
2 Plan the location. Make sure the area where the saw is installed has the following:
●A grounded power source. Check the saw’s serial- al tag for the correct amps, voltage, phase and cycles. All wiring should be completed by qualified personnel and should comply with your region’s electrical codes.
●Clearance for safe operation and maintenance. Make sure there is enough clearance around the saw for maintenance and servicing.
PREPARING FOR INSTALLATION
WARNING: Improper installation, oper- ation, or servicing may result in equipment damage or personal injury.
This equipment should only be installed, adjust- ed, and serviced by qualified technical person- nel who are familiar with the construction, oper- ation, and potential hazards of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical technicians in accordance with electrical codes in your region. Always maintain a safe ground. Do not operate the equipment at power levels other than what is specified on the machine serial tag and data plate.
UGE058/0803 | CTS Saw | INSTALLATION |
