We design equipment with the user’s safety in mind. You can avoid the potential hazards identified on this machine by fol- lowing the procedures outlined below and elsewhere in the User Guide.
DANGER: Sharp blades!
Most injuries caused by knife blades occur when the saw has been turned off. Handle blades with care at all times.
● Always wear
●Always lock out the saw before opening any guards.
●Always wait until the saw blade has stopped completely before opening the saw guard. (approximately five minutes)
CTS Saw are equipped with several safety devices to ensure safe operation. Never remove or disable these devices to sustain production. Operating without these devices can cause severe injury.
●The STOP button activates a circuit that stops the saw.
ATTENTION:
READ THIS SO NO
ONE GETS HURT
WARNING: Improper installation, operation, or servicing may result in equipment damage or personal injury.
This equipment should only be installed, adjusted, and serviced by qualified technical personnel who are familiar with the construc- tion, operation, and potential hazards of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical technicians in accordance with electrical codes in your region. Always maintain a safe ground. Do not operate the equipment at power levels other than what is specified on the machine serial plate.
UGE058/0803 | CTS Saw | INTRODUCTION |
