THE SAW CONTROL
IMPORTANT: Before applying power, ensure that the SAW BLADE UP and TABLE FORWARD valves are closed (fully clockwise), and that the saw blade is not installed on the
| 1 | Connect the electrical line cord to a source of power com- |
|
| patible with the nameplate on the saw |
|
| |
|
| Connect the air supply to the FRL |
| 2 | |
|
| on the saw. |
|
|
|
| 3 | If the optional dust collector was purchased, install and con- |
|
| nect the dust collector |
|
|
|
| 4 | Turn the main disconnect switch to the ON position; the |
|
| POWER ON light will illuminate. |
|
|
|
| 5 | Press Start or (if equipped with Dust Collector) turn Dust |
|
| Collector power “ON” first and then press saw motor “START” |
|
|
|
| 6 | Check the motor rotation. If the motor rotation is incorrect: |
|
| Reverse the connections at the AC plug end. |
|
|
|
| 7 | Once the rotation is correct, disconnect the power, and |
|
| install the blade on the |
|
|
|
| 8 | Make sure that the FRL is set for |
NOTE: Setting the FRL to higher level will only release air from the system. The CTS is equipped with a relief valve that is preset for approximately 70 PSI. The CTS is equipped with a relief valve that is preset for approxi- mately 70 PSI. The relief valve is in place to protect the air components from damage due to excessive air pres- sure.
| 9 |
| Press MANUAL CUT |
|
| Adjust the TABLE FORWARD speed control to match the | |
| 10 | ||
|
|
| approximate line speed. |
|
|
| |
| 11 | Adjust the SAW BLADE UP speed control to the desired | |
|
|
| blade travel speed. |
|
|
| |
| 12 | Set the blade height limit by adjusting the collar on the lifting | |
|
|
| rod (located on the table surface) |
|
|
| continued on the next page |
CTS Saw | UGE058/0803 |
