The operation of the saw consists of an automatic sequence of events.
1 To start the saw the main power must be on and the appro- priate air supply to the machine. With the power on, the control panel will have the power on light illuminated.
2 To start the saw motor, push the start button.
Once the saw motor is started, push the yellow manual cut button and the machine will start its automatic cycle. The clamps will come down and the table will begin to travel away from its home position. Immediately after this hap- pens, the saw pivot assembly will raise the blade up through the table slot until it reaches its up limit switch. Upon reaching this switch, the saw pivot will immediately return down through the table, the clamps will raise and the table will return to its home position, completing one cycle.
ELECTRICAL OPERATION
IMPORTANT: An important reminder is that the speed settings of the pneumatic flow controls will affect the cycle time of the machine. The flow controls must be set properly to a compromise between cycle time and cut quality. Flow control settings should be adjusted at this time and
UGE058/0803 | CTS Saw | OPERATION |
