Conair CTS 5, CTS 9, CTS 7 manual Maintenance

WARNING: Voltage Hazard

This equipment is powered by alternating cur- rent, as specified on the machine serial tag and data plate. Do not operate the equipment at power levels other than what is specified on the machine serial tag and data plate.

A properly-sized conductive ground wire from the incoming power supply must be connected to the chassis ground terminal inside the electri- cal enclosure. Improper grounding can result in severe personal injury and erratic machine operation.

Before performing maintenance or repairs on this product, disconnect and lock out electrical power sources to prevent injury from unexpect- ed energization or start-up. A lockable device has been provided to isolate this product from potentially hazardous electricity.

WARNINGS AND CAUTIONS

CONTINUED

DANGER: Sharp blades!

Most injuries caused by saw blades occur when the saw has been turned off. Handle blades with care at all times.

●Always wear cut-resistant gloves when the blade guard is open and when handling blades.

●Always lock out power to the saw before opening any guards.

●Always wait until the saw blade has com- pletely stopped before opening the saw guards. (approximately five minutes.)

CTS saws are equipped with several safety devices to ensure safe operation. Never remove or disable these devices to sustain production. Operating without these devices can cause severe injury.

UGE058/0803 CTS Saw MAINTENANCE 5-3