Conair CTS 5, CTS 9, CTS 7 manual V a n c e S o f t k e y, 20%

Conair Servo Traveling Saw

Operator Control Instructions

A d v a n c e S o f t k e y

Pressing the soft key located under the word Advance on the Table area screen. Selects the Table Advance Speed screen.

TABLE SYNC . RATIO

1 . 00:1

The number shown is the current table advance speed to encoder speed ratio. A cursor will appear in the least significant digit. The user has a choice of ways to adjust this number. The acceptable range is 1.20-0.80 to 1 (+/-

20%)

Exit or Prev-if no change is required press Exit or Prev to return to the Table area screen.

Raise will increase the preset by 0.01. The key can be pressed once for each 0.01 increment required or held down to scroll up. Releasing the key will freeze the preset at the last value.

Lower will decrease the preset by 0.01. The key can be pressed once for each 0.01decrement required or held down to scroll down. Releasing the key will freeze the preset at the last value.

Numeric keys

Key in the speed required and press enter. The decimal place is fixed so remember this when entering the ratio. If you require a 1.10:1 ratio you must key in 110 and then press enter. Keying only 11 will set the ratio to 0.11and the out of range warning will appear on the screen for 5 seconds.

Enter or Delete?

If the keyed in number is correct press the enter key for it to be accepted and return to the Main screen. If it is wrong press the delete key and the previous preset will reappear.

Appendix B-1 (15)