●Weekly
❒Blow or vacuum, dust and chips from all surfaces of the saw. Open pneumatic and electrical enclosures and remove the dust and chips from all compo- nents.
❒Check that the FRL
This unit also has an automatic drain for any mois- ture that may develop. The bowl should be kept clean to ensure it will operate properly.
●Quarterly
❒Blow or vacuum, dust and chips from the inside the saw. Remove all dust and chips from inside all control cabinets. Remove any excess oil from the pneumatic enclosure.
❒Verify that all electrical terminals are tight.
❒Check that all air lines are in order (free of cuts or abrasions). Check the saw travel rails and rollers for debris and wear.
❒Check that the adjustable mufflers on the SAW BLADE UP cylinder is set for a smooth downward return.
❒Check that the adjustable mufflers on the clamp cylinder are set so that the clamp operates quickly - a slow cycle on the
❒Check the condition of the clamp pads. If worn or damages, replace with a new set of pads.
❒Check the condition of the clamp pads. If worn or damages, replace with a new set of pads.
❒Check the condition of the blade. If the blade is dull, have the unit sharpened; if it is damaged, have the blade replaced.
PREVENTATIVE
MAINTENANCE
SCHEDULE
CONTINUED
WARNING:
Electrical hazard
Before performing main- tenance or repairs on this product, disconnect and lock out electrical power sources to pre- vent injury from unex- pected energization or
CAUTION: Moving parts
Before removing lock- out devices and returning switches to the ON position, make sure that all personnel are clear of the machine, tools have been removed and all safety guards are rein- stalled.
UGE058/0803 | CTS Saw | MAINTENANCE |
