CONNECTING
THE MAIN
POWER SOURCE
IMPORTANT: Always refer to the wiring diagrams that came with your saw before making electrical connec- tions. The diagrams show the minimum size main power cable required for your saw, and the most accurate electri- cal component information.
WARNING: Electrical hazard
Before performing any work on this product, dis- connect and lock out electrical power sources to prevent injury from unexpected energization or
WARNING: Improper installation, oper- ation, or servicing may result in equipment damage or personal injury.
This equipment should only be installed, adjust- ed, and serviced by qualified technical person- nel who are familiar with the construction, oper- ation, and potential hazards of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical technicians in accordance with electrical codes in your region. Always maintain a safe ground. Do not operate the equipment at power levels other than what is specified on the machine serial tag and data plate.
1 Open the servo saw’s electrical enclosure. Turn the disconnect dial on the door to the OFF or O position and open the door.
2 Insert the main power wire through the knockout in the side of the enclosure. Secure the wire with a rubber compression fitting or strain relief.
3 Connect the power wires to the terminals indicated on the wiring diagram that came with your machine.
4 Check every terminal screw to make sure wires are secure. Gently tug each wire. If a wire is loose, use a screwdriver to tighten the terminal.
5 Connect the ground wire to either grounding point shown in the diagram.
INSTALLATION | CTS Saw | UGE058/0803 |
