Conair Servo Traveling Saw
Operator Control Instructions
Length Softkey
By pressing the soft key located under the word Length on the Main Screen, the preset for the Length counter is available.
LENGTH 0000 . 00 0 in .
Exit
The number shown is the current length preset value, i.e. the length to cut the product. A cursor will appear in the least significant digit. The user has a choice of ways to adjust this number.
Exit or Prev- if no change is required press Exit or Prev to return to the Main screen.
Raise will increase the preset by 0.01”. The key can be pressed once for each 0.01” increment required or held down to scroll up. Releasing the key will freeze the preset at the last value.
Lower will decrease the preset by 0.01”. The key can be pressed once for each 0.01” decrement required or held down to scroll down. Releasing the key will freeze the preset at the last value.
Numeric keys
Key in the length required and press enter. The decimal place is fixed so remember this when entering the preset. If you require 24 inches you must key in 24000 and then press enter. Keying only 24 will set the length to 0.024 inches.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return to the Main screen. If it is wrong press the delete key and the previous preset will reappear.
Appendix
