Getting Started

1.4.2 Ribbon Loading Instructions

Load ribbon as shown below in Figure 1-7. The ribbon can be wound directly on to the hub and held with a clasp, or a used ribbon core can be placed on the hub. To load the ribbon complete the following steps:

1.Disengage the Printhead by rotating the Head-Lift Lever counterclockwise to the ‘up’ position.

2.Slide the Ribbon on to the Ribbon Supply Hub. Route the ribbon, (see Figure 1-7), and attach the ribbon to the Ribbon Take-up Hub.

3.Engage the Printhead by rotating the Head-Lift Lever clockwise to the ‘down’ position.

Figure 1-7 Ribbon Loading

10

Allegro2

Page 18
Image 18
Datamax Allegro 2 manual Ribbon Loading Instructions