Datamax Allegro 2 manual Maintenance, Interior and Exterior, Drive Roller

♦Maintenance

5.0Introduction

This chapter covers the cleaning receommendations for your Printer.

Interior and Exterior

∙Interior During normal operation dust particles from label stock can build up inside the Printer. To prevent build-up, use a soft bristle brush or vacuum cleaner as needed.

∙Exterior The exterior surface can be cleaned using a general purpose cleaner and a damp soft cloth or sponge. Do not use abrasive cleansers or solvents.

Drive Roller

Print quality may be affected if the drive roller becomes contaminated with grit, label adhesive, or ink. To clean the Drive Roller complete the following steps:

1.Remove the Tear-Bar Assembly, see Figure 1-4.

2.Turn the Head-Lift Lever to raise the Printhead to the ‘up’ position.

3.Dampen a clean, soft cloth with Isopropyl Alcohol and wipe off any debris from the Drive Roller.

Note: If the Drive Roller contains excessive build-up that is unable to be removed using Isopropyl Alcohol you can try acetone; however, this should be used sparingly.

Allegro2 70