dCS 974 User Manual | Manual for Software Version 1.0x |
dCS Ltd | May 2001 |
USING YOUR dCS 974 FOR THE FIRST TIME
What’s in the Box?
The contents of the box are at least:
dCS 974 User Manual Quick Start Guide Power cable
2 Spare Fuses Remote cable Remote software
Supply Voltage Setting
The dCS 974 is shipped with its supply voltage preset for operation in the destination country. The voltage is not intended to be changed by the user. If it needs to be changed, see the section Having Your Options Changed on page 114.
Getting Started
Here’s what to do:
(If the unit does not behave the first time you power up – contact your
do this: Check the appropriate mains supply for your local mains is marked on the rear panel.
do this: If it is, connect the unit to a power outlet using the cable supplied - connect no other leads at this stage - and switch on. The Power LED will light, then the screen will light up and display:
After approximately 20 seconds, the front panel LEDs will indicate the last stored state and the Unlocked LED will light. The screen will then display the Status Screen, for example:
do this: Connect a signal source to an appropriate input: AES 1, 2, 3 or 4, SPDIF1, 2 or 3 or
We recommend an AES3 source into the AES 1 input until you are comfortable with the unit. The procedure below assumes you have connected your source to the AES 1 input.
Manual part no: DOC1241121A1 | Page 110 | Document No: |
Contact dCS on + 44 1799 531 999 | email to: more@dcsltd.co.uk |
(inside the UK replace + 44 with 0) | web site: www.dcsltd.co.uk |