![](/images/new-backgrounds/1180133/18013391x1.webp)
NOTICE: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a
NOTICE: Not all operating systems support
1.Remove the bezel (see "Removing the Bezel").
2.If your replacement hard drive does not have a carrier, install the new drive on a carrier (see "Installing a Hard Drive on a Carrier").
3.Open the
NOTICE: Do not insert a
4.Insert the
5.Close the
6.Replace the bezel (see "Replacing the Bezel").
7.Install any required SCSI device drivers (see "Installing and Configuring SCSI Drivers" in the User's Guide for information).
8.If the hard drive is new, run the SCSI controllers test in system diagnostics.
Removing a Hard Drive From Its Carrier
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.
1.Remove the hard drive from the system (see "Removing a Hard Drive").
2.Remove the four screws that secure the drive to the carrier (see Figure
3.Remove the hard drive from the carrier.
Figure 4-19. Removing a Hard Drive From its Carrier
Installing a Hard Drive on a Carrier
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.
1.Insert the replacement hard drive into the carrier (see Figure
2.Install the four screws that secure the drive to the carrier.
3.Install the hard drive in the system (see "Installing a Hard Drive").
Integrated RAID Controller
To activate the integrated RAID controller, you must install three components, the RAID controller memory module, hardware key, and battery.
Activating the Integrated RAID Controller
CAUTION: Before you perform this procedure, read the safety instructions in your System Information document.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.