Dell PP20L owner manual Internal Card With Bluetooth Wireless Technology, card door, cable

Internal Card With Bluetooth® Wireless Technology

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer.

If you ordered a card with Bluetooth wireless technology with your computer, it is already installed.

1Follow the procedures in "Before You Begin" on page 109.

2If you have not already removed the battery, do so now.

Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the bay.

3Open the card door and remove it from the computer.

4Pull the card out of the compartment so that you can disconnect the card from its cable and remove it from the computer.

5To replace the card, connect the card to the cable and then carefully insert it into the compartment.

6Replace the card door by inserting the small center tab into the notch at the base of the compartment and snapping the card into place.

3

2

1

1 card door 2 cable 3 card

Adding and Replacing Parts

127