5Replace the computer cover (see "Replacing the Computer Cover" on page 121).

6If removing this drive changes the drive configuration, then be sure to reflect these changes in the BIOS. When you restart your computer, enter system setup (see "System Setup" on page 127). Then, go to the "Drives" section of the BIOS and under SATA 0 through 5, set the SATA ports to the correct configuration.

Installing a Hard Drive

1Follow the procedures in "Before You Begin" on page 77.

2Remove the computer cover (see "Removing the Computer Cover" on page 78).

3Unpack the replacement hard drive, and prepare it for installation.

4Check the documentation for the drive to verify that the drive is configured for your computer.

5If your replacement hard drive does not have the hard drive bracket attached, remove the bracket from the old hard drive by unsnapping it from the drive.

6Snap the hard drive bracket onto the replacement hard drive.

7Install the hard drive into the computer by sliding the drive into place until you feel it click into place.

1

2

1

hard drive

2

hard drive bracket

8Connect the power and hard drive cables to the hard drive.

106

Removing and Installing Parts

Page 106
Image 106
Dell YH242 owner manual Installing a Hard Drive, 106