5Disconnect the USB cable on the back of the Media Card Reader. Disconnect the other end of the cable from the USB connector on the system board (see "System Board Components" on page 81). Remove the cable from any clips and lift out of the computer.

2

1

3

1

sliding plate

2

sliding plate lever

3

Media Card Reader (not

 

 

 

 

 

present on all computers)

6Pull the sliding plate to the right and hold in place. Then, slide the drive out the front of the computer.

7Replace the drive panel insert (see "Replacing the Drive-Panel Insert" on page 102).

8Replace the drive panel (see "Replacing the Drive Panel" on page 103).

9Replace the computer cover (see "Replacing the Computer Cover" on page 121).

10Power up the system and enter system setup (see "System Setup" on page 127). Set the USB for FlexBay value to OFF.

114

Removing and Installing Parts

Page 114
Image 114
Dell YH242 owner manual 114, Sliding plate Sliding plate lever