Optimizing Performance 39
If a drive failure occurs, subsequent read and write operations are directed to the surviving drive. A
replacement drive can then be rebuilt using the data from the surviving drive.
NOTE: In a RAID level 1 configuration, the size of the configuration is equal to the size of the smallest drive in the
configuration.
Configuring Your Computer for RAID
Your computer can be configured for RAID, even if you did not select a RAID configuration when the
computer was purchased. You must have at least two hard drives installed in your computer to set up a
RAID configuration. For an explanation of RAID levels, see "About Your RAID Configuration" on
page37. For instructions on how to install a hard drive, see "Installing a Hard Drive" on page 106.
You can use one of two methods to configure RAID hard drive volumes. The first method uses the Intel®
RAID Option ROM utility and is performed before you install the operating system onto the hard drive.
The second method uses the Intel Matrix Storage Manager, or Intel Matrix Storage Console, and is
performed after you have installed the operating system and the Intel Matrix Storage Console.
Both methods require that you set your computer to RAID-enabled mode before beginning any of the
RAID configuration procedures in this document.
Setting Your Computer to RAID-Enabled Mode
1
Enter system setup (see "Entering System Setup" on page127).
2
Press the up- and down-arrow keys to highlight
Drives
, then press <Enter>.
3
Press the up- and down-arrow keys to highlight
SATA Operation
, then press <Enter>.
hard drive 1
segment 1
segment 2
segment 3
hard drive 2
segment 4
segment 5
segment 6
segment 1 duplicated
segment 2 duplicated
segment 3 duplicated
segment 4 duplicated
segment 5 duplicated
segment 6 duplicated
serial ATA RAID
configured for
RAID level 1
DIM_book.book Page 39 Monday, October 15, 2007 11:04 AM