Denon AVR-2803/983 manual Speaker system layout Basic system layout, System Setup Menu

@Auto Tuner Presets

System	setup						Defauk settings
		A1	-- A8	87	5/89 1/98 1/107 9/901/901/90//90/			MHz
		B1	-- B8	520/600//000/1400/1500//710			kHz,	90//90/	MHz
FM stations are received	automatically and stored it1 the memory	C1	-- C8	90	1	MHz
		D1	-- D8	90	1	MHz
		E1	-- E8	90	1	MHz

_ Setup Lock

Set whether or not to lock tile system setup settlrlgs so that they ca_mot be changed

Setup Lock = OFF

NOTES:

•The on-screen display signals are output with priority to the S-VIDEO MONITOR OUT jack during playback of a video component. For example, if the TV monitor is connected to both the AVR-2803/983'S S-Video and video monitor output jacks and signals are input to the AVR-2803/983 from a video source (VDP, etc.) connected to both the S-Video and video input jacks, the on-screen display signals are output with priority to the S-Video monitor output. If you wish to output the signals to the video monitor output jack, do not connect a cord to the S-VIDEO MONITOR OUT jack. (For details, see page 30.)

•The AVR-2803/983'S on-screen display function is designed for use with high resolution monitor TVs, so it may be difficult to read small characters on TVs with small screens or low resolutions.

•The setup menu is not displayed when headphones are being used.

•Speaker system layout Basic system layout

• The following is an example of the basic layout for a system consisting of eight speaker systems and a television monitor:

Subwoofer Center speaker system

Surround back speaker systems

	__
Front	speaker systems
Set these at the sides of the TV or screen with
their front surfaces as flush with the front of the		Surround speaker systems
screen	as possible

•Before setting up, connect the AVR-2803/983's MONITOR OUT connector with the monitor TV and turn off the power of all playback devices connected to the AVR-2803/983's video input connectors. (For instructions on connecting the monitor TV, see page 7 and 8.}

Check that all the connections are correct, then turn on the main unit's power.

SETUp Display the System Setup Menu.

To stop system setup before it is completed, press the system setup button again. System setup can be stopped at any time.

The changed settings are stored and the on screen display turns off.

System Setup Menu

_Speaker Configuration

Delay Time

Channel Level

Digital In Assignment

Video In Assignment

Dolby Digital Setup

Zone2 Control

•if you make a mistake at a system setup setting, you can reset it by selecting the desired menu from the System Setup Menu screen. The settings that have been changed up to that point are stored.

17