Denon AVR-2803/983 manual Flashes, Notes

If your AV component is not a Denon product or if it cannot be operated using the preset memory, it can be controlled with the accessorious remote control unit by storing its remote control signals in the remote control unit.

For some remote control signals it is not possible to "learn" the signals or the device will not operate properly. In such cases use the remote control unit included with the device to operate it.

1 Press the USE/LEARN button with the tip of a pen etc., to set the learn mode.

•Both the mode selector buttons and LEARNED/TX indicator flash.

Flashes

Press the mode button of the equipment for which learning is desired.

• Mode button and LEARNED/TX indicator flash.

CABLE

Press the button that is to be learned.
The LEARNEDfrX indicator stops flashing and the mode
button lights.
• Mode button and LEARNEDfrX indicator flashed	if a button
that cannot be "learned" is pressed.
• To cancel, press the USE/LEARN button.
		To "learn" other buttons, repeat steps 2 to 5.
Point the remote control units directly at each other and press
and hold in the button on the other remote control unit which
you want to "learn".	7
!		Once the learning operation is completed,	press the
		USE/LEARN button again.
	remote	The mode button and the LEARNED/TX indicator	stop flashing
Other		and the learning mode is cancelled.
control	unit

The mode button and the LEARNED/TX indicator lights, release the button on the other remote control unit.

•The mode button and the LEARNED/TX indicator start flashing again.

_e stored codes

work properly

NOTES:

•If the codes could not be stored, the LEARNED/TX indicator start flashing rapidly. For limited number of models, codes cannot be stored in RC-924.

•If the mode button and LEARNED/TX indicator start flashing rapidly, this means that the memory is already full, and the code you have just attempted to store was not stored.

To "learn" that code, first perform the resetting operation. (See page 39.)

36