Denon AVR-2803/983 manual Isurround

I_SURROUND

•Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup (see page 21) or from the remote control unit, as described below.

•Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the DOLBY/DTS SURROUND modes. The adjusted levels for the different modes are automatically stored in the memory.

1 Press the TEST TONE button.

{Remote control unit)

Testdifferenttonesspeakersare . outputUse thefromchannelthe

22

that the volume of the test tones is

the same for all the speakers.

volume adjust buttons to adjust so

1,3

{Remote contlol unit}
	After	completing	the	adiustment,
._	press	the TEST	TONE button again.
{Remote contlol unit}

• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below.

1	Select the speaker whose level you
(_._\	want to adjust.
{Remote contlo]	unit)

The channel switches as shown below each time the button is pressed.

Adjust the level of the selected speaker.

{Remote contlol unit}

When the surround back speaker setting is set to "lspkr" for "Speaker Configuration', this is set to "SB".

22

1

NOTES:

•The adjustment range for the different channels is +12 dB to -12 dB.

•The sound from the subwoofer can be cut by lowering the SW (subwoofer) setting one step from -12 dB (setting it to "OFF").

49