Denon AVR-2803/983 Setup, Menu, System, Speaker, Configuration, Delay, Time, Channel, Level, OPT1

When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect all surround modes. Consider this mode a Master Channel Level adjustment mode.

After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode on page 49.

You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, DOLBY/DTS SURROUND, 5/7 CH STEREO MONO MOVIE, ROCK ARENA, JAZZ CLUB, VIDEO GAME, MATRIX and VIRTUAL.

•This setting assigns the digital input jacks of the AVR-2803/983 for the different input sources.

1	At the System Setup Menu select "Digital In Assignment".		Setup		Menu
	System
	Speaker		Configuration
	Delay	Time
	Channel		Level
	ErDigital		In	Assignment
	Video	In	Assignment
	Dolby	Digital			Setup
	Zone2	Control
2	Switch to the Digital Inputs screen.		In	Assignment
	Digital
	_]:<F_'I_			_:	OFF
	[_:	COAX2		_:	OFF
	[_:	OPT1		[_:	OPT4
	[_:	OPT2
	[_:	OPT3
	[_:	OFF		Default[_<

Select the digital input jack to be assigned to the input source.

•To select the input source

•To select the digital input jack

Select "OFF" for input sources for which no digital input jacks are used.

•_ If "Yes" is selected for "Default", the settings are automatically reset to the default values.

The System Setup Menu reappears.

(_ Enter the setting.

NOTES:

•The OPTICAL 4 jacks on the AVR 2803/983's rear panel are equipped with an optical digital output jack for recording digital signals on a CD recorder, MD recorder or other digital recorder. Use this for digital recording between a digital audio source (stereo 2 channel) and a digital audio recorder.

•Do not connect the output of the component connected to the OPTICAL 4 OUT jack on the AVR-2803/983's rear panel to any jack other than the OPTICAL 4 IN jack.

•"PHONO" and "TUNER" cannot be selected on the Digital in Assignment.

23