Denon AVR-2803/983 Last Function Memory, Initialization Of The Microprocessor, Shift, Tuning

• Recaifing preset stations from the remote control unit.

SHIFT		Watching	the	display,	press	the
		SHIFT button to select the preset
		memory block.
{Remote	control	unlt}
2		Watching	the	display,	press	the
		CHANNEL	+	(up) or	- (down)
		button to select the desired preset
		channel.
{Remote	control	unlt}

1

9 ¢ ®,-®

o® 2

O)OOOO

• Recalling preset stations from the main unit's panel.

TUNING	Press the TUNING PRESET button.	1 2
PRESET

{Main	unitl
.... .....		Turn	the	FUNCTION	knob and
_O	_	select	the	desired preset	channel
{Main	unlt)

t

[] LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a beck-up memory. This function provides approximately one week of memory storage from when the main unit's power switch is off and with the power cord disconnected.

[] INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows microprocessor is required by the following procedure.

Switch off the unit and remove the AC cord from the wall outlet.

o o o o *

Hold the following FRONT SPEAKER button and ZONE 2 button, and plug the AC cord into the wall outlet.

1

the reasonable result, the initialization of the

I

2

Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons and the microprocessor will be initialized.

NOTES:

•If step 3 does not work, start over from step t.

•If the microprocessor has been reset, all the settings are reset to the default values (the values set upon shipment from the factory).

63