Denon AVR-2803/983 manual Example: Stereo, Input mode display, Input signal display

Select the play mode.

Example: Stereo

Input mode display

• in the AUTO mode

INPUT

One of these Hghts, depending on the input slgna_

8UF_JNDSELECT

_E_O

MODE_O_

(Main unit) (Remote control unit)

To select the surround mode while adjusting the surround parameters, channel volume or tone control, press the surround mode button then operate the selector.

SURROUND

MO_E

{Mainunit)

Start playback on the selected component.

• For operating instructions, refer to the component's manual.

Adjust the volume.

The_elis
d_splayed on the	(Main unit)	(Remote control unit)
master volume _evel
display

'_The volume can be adjusted within the range of -80to 0 to 18 dB, in steps of 0.5 dB. However, when the channel level is set as

descnbed on page 21 or pages 49 and 50, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. {In this case the maximum volume adjustment range is "18 dB -- {Maximum value of channel level)".}

Input mode when playing DTS sources

•Noise will be output if DTS compatible CDs or LDs are played in the "ANALOG" or "PCM" mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL} and set the input mode to "DTS'.

_UT9 PCM _TS

@ o @

/i k

•in the DIGITAL PCM mode

_NPUT

AUTO \p_OTS

o o o

•in the DIGITAL DTS mode

_NPUT

AUTO PCM _TS_

o o o

_1 k

•in the ANALOG mode

INPUT

AUTOpCMDTS

o o o

Input signal display

•DOLBY DIGITAL

			O
•	DTS
		D GITA0 _	C
•	PCM
		0	0
	The	_	indicator	lights	when	digital signals		are	being input
	properly.		If the _	indicator does not			light,	check whether
	the digital input component setup {page 23) and connections are
	correct and whether the			component's power			is turned		on.
NOTE:
•	The	_	indicator will		light	when	playing		CD-ROMs
	containing data other than audio signals, but no sound will be
	heard.

43