Denon AVR-2803/983 manual DVD preset codes 0000 0001

The included remote control unit can be used to operate devices of different brands by registering the preset number corresponding to the brand of your device.

For some models the remote control unit or the device may not operate properly. In this case, use the learning function {page 36) to store your device's remote control signals in the included remote control unit.

1	Press the power ON/SOURCE button and the OFF button at
	the same time.	1

• The LEARNED/TX indicator flashes.

2

Press the mode button ofthe equipmentthatis to be entered to a presetrnemory.

• The mode button flashes.

C2D (3E) CAD

			Referring to the included List of
(_)	(_)	@	Preset	Codes,		use	the		number
([_)	@	@	buttons	to input		the	preset		code (a
			4-digit	number}				for	the
(Z)	@	@	manufacturer		of	the		component
	(_)	_.'_	whose	signals	you want			to store in
			the memory.

When stored correctly, the mode button and the

LEARNED/TX indicator will light.

To store the codes of another component in the memory, repeat steps 1 to 4.

NOTES:

•Depending on the model and year of manufacture, this function cannot be used for some models, even if the your device is listed on the included list of preset codes.

•Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and check it out.

•The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE.

The preset codes are as follows upon shipment from the factory and after resetting:

TV, VCR		HITACHI
CD, TAPE		DENON
CDR/MD		DENON	(CDR)
DVD/VDP		DENON	{DVD)
DBS/CABLE		ABC (CABLE}
DVD preset codes	0000	0001
	DVD-900
	DVD-1000	DVD-800
	DVD-1B00
		DVD-1600
	DVD-2800
		DVD-2000
DENON Model No.	DVD-2800I[
		DVD-2500
	DVD-3800

DVD-9000

DVD-3000 DVD-3300

DVM-1800 DVM-4800

33