Denon AVR-2803/983 Adjusting the sound quality Tone, Basstreble, Listening over headphones, Video

[1] Adjusting the sound quality (TONE)

•The tone control function wifl not work in the direct mode.

•The tone control setting only affects the front speakers.

•if the tone control function is used, the main volume cannot be adjusted surround modes.)

The tone switches as follows each time the TONE CONTROL button is pressed.

TONE

O_ITROL

			BASS_TREBLE
	{Main unit)
2	With the name of the		volume to be	SELECT
	adjusted selected,	turn	the SELECT	B_l
	knob to adjust the level.
	• To increase the	bass or treble:		(Mainunit)

Turn the control clockwise. {The bass or treble sound can be increased to up to +10 dB in steps of 2 dB.)

•To decrease the bass or treble:

Turn the control clockwise. {The bass or treble sound can be decreased to up to -10 dB in steps of 2 dB.)

up to 18 dB. (The maximum main volume level differs in the different

.--

o o o o = •

@

	231
If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
T_IE
DEFEAT	The signals do not pass through the
	bass and treble adjustment circuits,
	providing higher quality sound.

[2] Listening over headphones

Plug the headphones' plug into the jack.

the PHONES jack.

The pre-out output (including

"_ Connect the headphones to

the speaker output) is automatically turned off when headphones are connected.

_PHONES

_ _AI 1L

l ol • 1

1

NOTE:

To prevent hearing loss, do not raise the volume level excessively when using headphones.

[3] Turning the sound off temporarily (MUTING)

Use this to turn off the audio output

Press the	MUTING		button.		1_._
temporarily.
-_ Cancelling		MUTING		mode.
Press	the	MUTING		button again	or
adjust	the	main	volume level.		{Remotecontrolunit)

[4] Combining the currently playing sound with the desired image

Simu[cast playback					VIDEO	_ur,-_o.
video source other than the
audio	source.			monitor a	s_.,_	,I_Q_-
Use this		switch to
Press	the		VIDEO	SELECT
button,		turn	the FUNCTION
knob		until	the	desired		(Malnunit)

source appears on the display.

-_ Cancelling simu[cast playback.

•Select "SOURCE" using the VIDEO SELECT button and the FUNCTION knob.

•Switch the program source to the component connected to the video input.

11

I

Display

I]:H.....U i:d::iUF;:CEI

45