119OM 8/28/06 11:43 AM Page 10
Assembly Instructions
35mm screws using an Allen wrench. Be sure not to pinch the hand pulse harness during this procedure, as this will damage the electronic console.
Step 5: Console Assembly
1.Connect both plugs, from main wire harness and hand pulse harness, to the plug receptors on the backside of the console, taking care to install correctly (see plug alignment marks).
WIRING HARNESS INSTALLATION HINT: Any excess wiring must be carefully inserted (“stored”) back into the console mast before installing the console onto the console mounting plate.
2.Fasten the console to the console mounting plate with the four M5 x 12mm screws and washers, using a Philips screwdriver.
Step 6: Water bottle & Leveling Pads
1.Place the water bottle into the water bottle holder.
2.2. Adjust the leveling pads if necessary, located on the front stabilizer bottom, to ensure your equipment is leveled with floor.
8 |
|
1190 Er Owner’s Manual |
