Dukane 8944 user manual Image Menu, Over Scan, Position

IMAGE Menu

IMAGE Menu

From the IMAGE menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.

/'07=4)$?	5'.'%6
		
2+%674'	#52'%6
+/#)'	18'45%#0
+0276	8215+6+10
5'672	*215+6+10
#7&+1	*2*#5'
5%4''0	*5+<'
126+10	#761#&,756':'%76'
/+7	
'#5;/'07

Item	Description
	Using the ▲/▼ buttons switches the mode for aspect ratio.
	For an RGB or MIU signal
	NORMAL ó 4:3 ó 16:9 ó SMALL
	For an M1-D signal
ASPECT	NORMAL ó 4:3 ó 16:9 ó 14:9 ó SMALL
	For a Video signal, S-video signal or Component video signal
	4:3 ó 16:9 ó 14:9 ó SMALL
	For no signal
	4:3 (fixed)
	• The NORMAL mode keeps the original aspect ratio of the signal.
	Using the ▲/▼ buttons adjusts the over-scan ratio.
OVER SCAN	Large (It reduces picture) ó Small (It magnifies picture)
	• This item can be selected only for a video, s-video and component signal.
	• When this adjustment is too large, certain degradation may appear
	at the frame area of the picture. In such a case, please adjust small.
	Using the ▲/▼ buttons adjusts the vertical position.
	Up ó Down
	• Over-adjusting the vertical position may cause noise to appear on the screen. If this
V POSITION	occurs please reset the vertical position to the default setting. Pressing the RESET button
	when the V POSITION is selected will reset the V POSITION to the default setting.
	• When this function is performed on a video signal, s-video signal, or
	component video signal of 525i (480i) or 625i (576i), the range of this
	adjustment depends on the OVER SCAN (above) setting. It is not
	possible to adjust when the OVER SCAN is set to 10.
	Using the ▲/▼ buttons adjusts the horizontal position.
	Left ó Right
	• Over-adjusting the horizontal position may cause noise to appear on the screen. If this
H POSITION	occurs please reset the horizontal position to the default setting. Pressing the RESET
	button when the H POSITION is selected will reset the H POSITION to the default setting.
	• When this function is performed on a video signal, s-video signal, or
	component video signal of 525i (480i) or 625i (576i), the range of this
	adjustment depends on the OVER SCAN (above) setting. It is not
	possible to adjust when the OVER SCAN is set to 10.

(continued on next page)

30