Dukane 8944 user manual Inserting an SD card and USB memory, Type of card

Setting up

Inserting an SD card and USB memory

When using the projector with a wireless LAN please insert the included wireless network card. When using a commercial SD memory card in order to view images insert the SD memory card in the same manner. And when using a commercial USB memory in order to view images insert the USB memory to the AUX I/O port. See this “User's Manual - Network Function Section” for information on using either

type of card.

		Wireless
		communication
			RGB OUT		LAN
Wireless
communication				USB
Insert the Wireless
				memory
network card
			AUX I/O	LAN
			DC 5V 0.5A
		RGB	RGB1	RGB2	M1-D
		OUT
AUDIO IN 1	VIDEO	Y	CB/PB
AUDIO IN 2
			CR/PR
		R L	R L	AUDIO	REMOTE
	S-VIDEO				CONTROL
		AUDIO IN 3	AUDIO IN 4	OUT	CONTROL

AUX I/O port

SD card slot

Angled corner

1. Make sure the projector’s power switch is OFF.

2. Remove the SD card slot cover. Pull the cover forward, pushing slightly its edge up, to remove it from the projector.

3. Insert the SD card. Slowly insert the SD card completely into the SD card slot. Make sure the angled corner of the SD card is facing the right side (AUX

I/O port side) of the projector while inserting.

4. Replace the SD card slot cover. Replace the cover by reversing the procedure used when removing the cover.

NOTE • When using the projector with a wired LAN, please remove the wireless network card.

•Before removing the SD card or USB memory, be sure to perform the REMOVE procedure using the SERVICE menu under the MIU menu (58). IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- llocated or operating in conjunction with any other antenna or transmitter.

12